HIGHSIDER AKRON-RS RSH

HIGHSIDER AKRON-RS RSH YZF-R1 02-03/YZF-R6 03-06

Why does it actually need a different number plate holder? Probably for "cosmetic" or visual reasons. Whatever the case, the HIGHSIDER *AKRON-RS* licence plate holder is exactly what you are looking for. Because in terms of design, it adapts perfectly to the lines of your bike.
The model-specific HIGHSIDER *AKRON-RS* holder can be mounted exactly at the original attachment points of your motorbike. For you, this means: only exchange - no drilling or cutting. The licence plate is made of sheet steel, 2 mm thick and powder-coated.

• Vehicle-specific holder
• Suitable for European number plates
• Steplessly adjustable angle of inclination
• Steplessly adjustable indicator holder
• Slotted indicator holder for quick mounting without cable separation
• Continuously adjustable reflector
• simple fixing without further work steps (e.g. drilling)
• Easy mounting of the number plate through slotted holes
• Many different options for mounting the licence plate light
• Reflector E-approved

• if side reflectors are fitted to your original number plate holder, these must be refitted in a suitable position or replaced with new ones
• to avoid damage to cables, all sharp-edged feed-throughs are protected by a rubber membrane grommet
• stepless adjustment: this allows you to adjust the plate to the desired position without drilling. To keep the plate in this position, there is an additional securing screw
• Two rubber washers are included to secure the plate and reduce vibrations. Another rubber buffer supports the number plate on its underside.
• the indicator brackets of the HIGHSIDER *AKRON-RS* are adjustable in width and therefore suitable for any type of accessory indicator. This allows you to adjust the position of the turn signals to suit a wide range of number plates.
• To enable the turn signals to be mounted without disconnecting them from the wiring harness, the 10 mm holes are slotted to the side
• the bracket is adjustable in height and designed to allow mounting in the legally prescribed position
• you can also adjust the position of the rear reflector individually via a slider. Adaptation to the different designs of EU number plates is done in no time at all.